G50 Series Compressed Air Filters

High efficiency compressed air filters for industrial applications requiring pressures of up to 50 barg.

Полное описание продукта

Most industrial compressed air applications operate at pressures around 7, 10 or 13 bar g and purification equipment is typically designed around these operating pressures. There are however, applications that require higher operating pressures (which also leads to increased concentration of many contaminants).

The Parker GH50 Series Intermediate Pressure filter range is available in multiple filtration grades to cover all filtration requirements, including general purpose and high efficiency coalescing grades, general purpose and an oil vapour reduction grade.

Features
• Meets the requirements for delivered air quality shown in all editions of ISO8573-1, the international standard for compressed air quality

• Pleated filter element – Coalescing & Dry Particulate filter media is constructed to reduce air flow velocity and pressure loss whilst providing increased dirt holding capacity, and improved filtration efficiency

• Filter element is secured by tie-rod to ensure element is held in place, even with pressure pulsations commonly experienced with piston compressors

For more information or a detailed discussion about your specific requirements please contact Parker or an authorised Parker distributor.

Характеристики

Подразделение:	Gas Separation and Filtration Division EMEA
Бренд:	Parker
Технологии:	Filtration
Тип продукта:	Compressed Air Filter
Тип фильтра:	Coalescing, Dry Particulate and Oil Vapour Reduction
Серия продуктов:	G50 Series
Применение:	Compressed Air and Nitrogen Gas Applications
Промышленность:	Industrial Manufacturing EquipmentFood & BeverageAutomotiveElectronicsPharmaceuticals
Расход:	75 to 2600 m³/hr @ 7 barg(44 to 1530 cfm @ 102 psig)
Показатель эффективности фильтра:	Grade ZP: 99.925%Grade XP: 99.9999%Grade A: Not Applicable
Номинальное значение в микронах:	Grade ZP:Down to 1 micronGrade XP:Down to 0.01 micronGrade A: Not Applicable
Размер порта:	¼ to 2 inch
Тип соединения:	BSPP
Остаточное нефтесодержание:	Grade ZP:0.5 mg/m³ / 0.5 ppm(w)@ 21°C (70°F)Grade XP:0.01 mg/m³ /0.01 ppm(w)@ 21°C (70°F)Grade A:03 mg/m³ /03 ppm(w)@ 21°C (70°F)
Материалы изготовления:	Die Cast Aluminium
Слив:	Manual Drain
Рабочее давление:	20 to 50 barg(290 to 725 psig)
Рабочая температура:	ZP/XP:2°C to 80°C(35°F to 176°F)A:2°C to 50°C(35°F to 122°F)
Совместимый элемент:	Grades ZP/XP or A Depending on Model
Интервал между заменами элемента:	Grades ZP/XP:12 months or 6000 hoursGrades A:When oil vapour is detected
Соблюдены требования технических условий:	PED 2014/68/EU Fluid Group. II.
Высота:	200 to 735 mm(7.9 to 28.9 inch)
Ширина:	61 to 164 mm(2.4 to 6.5 inch)
Вес:	0.8 to 8.9 Kg(1.7 to 19.7 lbs)