Pneumatic Slide Table, P5SS Series / Parker Pneumatic - Europe P5SS-008DSG040B

Примечание: Этот продукт больше не доступен - пожалуйста, свяжитесь с нами для получения дальнейшей помощи.

The P5SS is a pneumatic double acting slide table available in bore sizes Ø6, Ø8, Ø12, Ø16, Ø20 to Ø25mm. Operated by two cylinders mounted in parallel achieving increased thrust to profile ratio for accurate moving of loads on its mobile carriage or tapped front tool plate. End stroke buffer cushioning is provided as standard but for heavier loads and increased cycle times optional hydraulic shock absorbers for bores Ø8 to Ø25mm allow for rapid safe positioning. With a magnetic piston is standard, optional sensors mounted in the integrated protected sensor grooves allows positional detection. Optional stroke adjusters cover millimetre increments between the standard strokes.


General Technical Data:
• International standards : N/A
• Bore Sizes : Ø6, Ø8, Ø12, Ø16, Ø20 and Ø25mm
• Stroke Length : 10 to 150mm
• Versions : Double acting
• Cushioning : Rubber Buffer (standard) / Hydraulic Shock Absorber (optional on bores Ø8 to Ø25mm)
• Position Sensing : The P8S family of sensors provides a broad range of reed and solid state sensor types with flying lead or M8 options available. Mounting on all grippers is within the integrated sensor grooves allowing for compact installation.
• Electronic Sensors : Utilise “Solid State” technology, providing operation with no moving parts. These switches are available in NPN and PNP type, both provide built in short circuit and transient protection as standard. The solid state operation allows for high switching on off frequency, ideal for applications where long service life is required.
• Reed Type Sensors : Are based on proven reed switch technology and provide reliable function in many applications. Simple installation and the available AC voltage range are advantages for this range of sensors.
• Installation : Direct mounting.
• Mounting Position : Any

Operating and Environmental Data:
• Operating Medium : For best possible service life and trouble-free operation dry, filtered compressed air to ISO 8573-1:2010 quality class 3.4.3 should be used. This specifies a dew point of +3°C for indoor operation (a lower dew point should be selected for minus temperature operation and we recommend the use of an inline dryer) and is in line with the air quality from most standard compressors with a standard filter.
• Operating Pressure : 1.5 to 7 bar
• Operating Temperature : -5°C to +60°C
• Pre-lubricated : Further lubrication is normally not necessary. If additional lubrication is introduced it must be continued.
• Corrosion Resistance : Resistance to corrosion and chemicals.

Material Specification:
• Body : Aluminium alloy
• End Covers : Aluminium alloy
• Table : Aluminium alloy
• Piston : Stainless steel (Ø6 and Ø8), Aluminium alloy (Ø12 to Ø25)
• Seals : NBR (Nitrile rubber)
• Piston Rod : Stainless steel

Характеристики